just left work today and magically all 3 lights are on i had a exedy twin hd installed by buschur in feb, has the "seal bark" noise from dead stop that but aside from that feels ok , latly has been a lil easier to shift if that makes sense real smooth, now today i have all the acd lights on called dealership they said its the hydralic pump without even looking at it is there anything else it could be or suggestions?

 

it happens to me after a short, it's like these 3 acd light easily turn on when theres something else than that hydrolic pump

 

Pump, air in the system, something like that. They must see a lot of them there to just throw out the pump. Sounds like you need a little diag time...or a magic wand j/k

 

could i get dealership to bleed acd system maybe, i read that in another thread. i dont want to drop 2200 now haha

 

Don't see why it would be a problem to have it bled. When I did my clutch and had to bleed the ACD I just put a vacuum bleeder on the bleeder screw and let it do it's thing for like 20 sec or so.

I've done a couple cars like that and it's always worked for me...if it is indeed air in the system.

 

mines been like this for a while, one light on at start up, once wheel roll, blip all three. you can cycle the pump by turning the key on and holding the gas down. you should be able to hear it for a brief second. you will have to do it many times if it does indeed work, however with mine, its dead.

good luck to you.

 

you could actually bleed it yourself. its actually simple. just floor the gas pedal then switch the key to on(not start just on). the acd pump should run for abt 10 sec. you should hear it or have someone infront of that car to listen for it.

 

what should my next move be? i have been driving car conservative just 17 miles to work each day all highway i could see if i was launching it all the time

 

You've gotten some pretty good responses here on your 'next move' if you don't want to work on it take it somewhere and have it fixed...can't fix it over the internet...launching has nothing to do with it.

 

so if i hear it kick on thats a good thing haha

 

yes

 

either low fluid or you need a new pump

 

had the acd fluid changed at about the 60k mark from dealerhsip better check it though

 

i reset the ecu dunbo if it makes a difference or not for few mins aka pull neg batt cable, turbed key to on and did hear something kick on little whine and only 1 light lit up and would cycle through all when hitting button to change. maybe just fluke thing? or i need ot drive to see if it happens again

 

lol is that easy to fix that ?