so here is my problem,
i just had my tilton twin disk shear the splines on the disc hubs so i was installing brand new discs and i have the car all the way back together now and i bled the clutch line which seems to be a little aerated so i may be sucking in air somewhere. but tha isnt my main concern, my HRB hydraulic release bearing is resting directly on the pressure plate fingers and when the clutch pedal is pushed in the fingers are pushed in towards the flywheel. i adjusted my pedal both ways to see if that changed it but no luck. when i stroke the clutch it makes a noise but not a twin disk noise more of a low rumble or very quiet rattling but i cant go into any gear. is that bearing supposed to sit that close to the pressure plate? or is there any adjustments i can make to the hrb with it still on the car? plz help this is my DD and i need it for work in the morning.

 

Anyone? I really don't know where to start

 

Sorry m8, I'm no help here... but I think there was a thread about clutch installation just a few pages back? Maybe try there?

 

its ok, im looking around the forum and it seems fairly common...i need my car asap