Can anyone recommend me a decent prices high quality shaft seal? I've read a few do not hold up as good as others. The car will be on 25psi + so I need one that won't fail anytime soon!

 

http://www.streettunedmotorsports.co...haft_seals.htm

 

^^ these.. The MIlspec shaft seals are awesome.

 

I'd definitely go with the mil spec shaft seals. Great product and not expensive at all.

 

Awesome, it was this or STM's shaft seal. I need them overnight-ed either way.

 

Are your oem ones leaking? 90% do above 25 or so psi but some don't! Lol may as well leak test it at that psi and see?

 

My oem ones started leaking at 11-13 psi!!! Went with the Mil Spec ones and they havent leaked yet, and I regularly boost leak test to 30 psi.

 

Wow! Lol my oem ones haven't leak yet knock on wood !!! Lol idk how.

 

The car has 99,9xx miles on it, & my idles acting funky, I'm assuming its thus because I've replace every other seal/gasket that could leak. Fingers crossed!

What company overnights?

 

What do you mean funny idle? If they are leaking I would certainly replace but there's no guarantee that is the cure for the idle. What about iac, egr, etc

 

Just deleted egr, double checked the block off plate. No leaking. All vacuum lines replaced today. How do u suggest i check iac? The plugs are new aswell

 

i would check it in evoscan if you have it.

on the shaft seals i would get mil spec as well. they are a pain to install if you arent careful they bend easily and are screwed.

 

Ahh I'll find a write up on the install, Yeah I have evoscan my harddrive crashed so I'm using my phone until the new harddrive comes in.

 

If it were me being they are decently inexpensive I would order two sets so you can mess up a set if it happens and you have others readily available. I also had an idle problem awhile back and it turned out being the egr I think. I checked my iac by removing it from the car and checking the pins for resistance with a multimeter you can also unbolt it leave it plugged in the sensor and turn the key to on I believe it is supposed to click and search in and out for idle position.

 

+1 for Milspec, but I doubt you're going to get them overnighted from anywhere.