Just wanted to share that these things look awesome and installation was simple and what problem I encountered.

I basically tried following EvoMoto procedure but noticed that they either made a mistake with harness pin numbering or their connector was different.
I checked the Evo service manual for wiring diagram and it tells you which color wire goes to battery and which one to the ignition. The colors match EvoMoto scheme.

The rest is simple...
I didn't solder because I'd have to get one of those gas solder irons (don't have a garage ) and since you can't buy one in the store that would be a week more waiting.
So I used the supplied connectors. Very simple, just follow the Defi manual. It's easier if someone helps you hold the wires while you press the plastic pieces together though, I did it alone and it was a *****

 

Lack of skill Sasha .. Lack of skill... tsk tsk tsk
j/p

did u get your hardy panel in the mail yet? SHould be getting mine by friday. I have the same guage setup