I would like to see pix of where people mounted the fan module. That's the problem I'm having.

 

x2

 

So shoot me an email address and i will send it to you. I took a pic, I will tell you now its from under the car and not a lot ot look at. You will see the intake pipe and If I am not mistaken I used the mounting hole for the 3 port boost controller--or 2 port if you s are stock, on the frame--drivers side. just mounted the module there by 1 ear, with wires facing downwards, so any water doesnt puddle up and cause a prob.

 

i just ordered a mishimoto radiator im on stock turbo do i need to buy a new fan or could i use the oem fan

 

hope this helps. basically took 2 zipties, ran it through the radiator and mounted. just use the very last fin on the end since zip-tying causes the fins to bend.

 

Thanx guys!!!

 

I decided to use self tapping screws and mount it on the frame.

 

Excellent thread. Im assuming the module is necessary as no one here mentions deleting it. Is anybody running without this module and if so, how effective is it? Does it run constantly? I WOULD LIKE to wire my fan to run Constantly.

Any ideas?

 

This is awesome! Thanks!

 

Unfortunately doing it like this the module and its sensor (the whole aluminum face with all the little dimples) will not read the temperature of the radiator so it may come on after a long delay. Having it right behind the radiator makes it come on as needed sensing the actual temperature.

 

The module is only necessary if you want to the fan to come on and off as needed. If you delete the module and just connect the positive and negative wires to your fan, it would run all of the time that your car is on.

 

It does not matter were it is mounted there is no sensor on the box it is just a high and low relay .

 

Did you guys just splice the wires in? Did anyone disassemble the plug itself and put the new wires in it? Like a dummy i pulled a wire out of the plug.