Who makes the DS2500 pads? Where can I get these?

Dan

 

Ferodo and you can get them from us

We only sell a few pads for the EVO and the DS2500 is our favorite aggressive street pad. Its easy on the rotors, has great life, and performs very well.

 

Plz pm the price for two sets (front and rear being a set), shipping excluded.


Rgds
Elie

 

Pmed

 

pm me a price shipped for the DS2500 to 11566 both front and rear! Thanks!

Dan

 

You too have a PM.

 

I've run the OE, DS2500s, HPS, and now have the HPS+. These are by far the best pads that I've used for street and road racing. This initial bite is much better than I expected and they hold up well on the track. I'm not sure about rotor wear yet, but they bite so well, I don't care. The 2500s and HPS just disintegrated on the track...

 

HP+ pads are the best pads for autocross and work wonders on the street. We don't sell Hawk but if you’re an autocrosser we say HP+. They have a lower operating temp because their cold bite is their strong point. High speed and continuous braking is where the HP+ will fall off but yes they are great pads.

 

Hawk Blues ( noisy/ dusty ) but there unreal when heated up.

 

And I followed his advice
what an awsome race pad

 

What PFC part number do you use for the 97s in the rear? Used to be 0109.97.16.44, but for some reason, I keep being told that's discontinued. Can only get 01.

 

After days of searching I found AMS stocks them. They have to order 10 sets at a time last I talke to them.

 

Should have been running "track pads". For Ferodo, the DS 3000s would have served you well.