I just got my alpine pdx5 and crossovers in today but i dont know how to wire the factory system inputs into this amplifier since it has RCA inputs. any suggestions? Do i use LOC on certain wires?

also, which wire did you use for the remote wire? im sure i can tap right into one of those. i have all the wiring diagrams in alldata but im not too good at reading electrical diagrams

 

bump!

 

Im not sure about the wiring into the rockford amp but the remote wire will have to be from a ignition key source. The Rockford uses a canbus system so it doesnt need a remote signal to turn on.

 

Found that info from this thread, which should help you out alot..

https://www.evolutionm.net/forums/ev...d-oem-amp.html

Scroll down to the 4th post for pix and wiring details.

..and good luck!