A few small corrections in the 53600010 map...
I am going to go out on a limb here and defend Colby. I dont really care that ECUFlash is buggy, I havn't really hit any bugs - it does what I need it todo, and Colby is pretty keen to add new features...
Now after going through the X flashing code myself it is apparent that Colby has put a LOT of time and effort into getting it to work.
Now after going through the X flashing code myself it is apparent that Colby has put a LOT of time and effort into getting it to work.
.. and yes .. alot of effort was put in .. Colby wanted to delay the release of the software because of some minor issues and bugs .. but overall it seemed easy to everyone else .. because they weren't there (neither was I hehe .. had MRFred to thank though) ..Maybe we should have advised Colby not to release the software eh ??
And I have the same table as compensation too
.. so different names same ideas..I may send you an email later .. cause I'm having problems 'stitching' additional codes together
.. need your expertise here ..
Evolved Member
Joined: Mar 2008
Posts: 730
Likes: 3
From: Lattitude 48.38°, Longitude 17.58°, Altitude 146m = Slovakia, for common dude
I should have a bench setup for my spare IX ECU in the next month, and then we'll see what I can put together.
(By the way, I hope you don't think any of my post was directed at you; I can actually see Colby's point of view in this, but I just think he needed to man up and do what he promised, rather than quietly ignoring the issue.)
(By the way, I hope you don't think any of my post was directed at you; I can actually see Colby's point of view in this, but I just think he needed to man up and do what he promised, rather than quietly ignoring the issue.)
as I have started with MUT_01, MUT_03 disassembly and I will need helping hand
Thread
Thread Starter
Forum
Replies
Last Post
mrfred
Evo X Engine Management / Tuning Forums
82
Jan 3, 2020 04:18 PM
logic
ECU Flash
78
Nov 8, 2018 04:17 AM
