i just flashed my car with athe stage 1 map i have a catback and i was wondering what data to look at and what to look for as far as dangerous conditions . i was monitoring knock retard and i would get .35 and .7 randomly at lower rpms sometimes around 2500rpm and some around 4500 is this ok ?

 

I think .35 and .7 counts of knock retard when it's random like that. I think it's helpful to look at the LTFTs as well. I'm also wondering what to look for in the AP logs as well.

 

log boost as well....

 

i have been logging after doing the stage 1 map and i have been getting .35 .7 not constantly but quite abit never really in the same spot but twice i got 1.7 and 2.11 is this safe

 

1.7 and 2.11 are not the best to see. But if they are random, its hard to fix. Our cars seem to have a very sensitive knock sensor.

 

I think my ap is broken, my boost goes over 200 sometimes.

 

Are you sure thats not Load Boost? Try logging the value called "Boost Pressure"

 

How much knock does everyone else have ?

 

I see .35 and .7 randomly all the time. I can do a full pull and get 0, and then get .7 while idling at a stop light. Other times I see the .35 or .7 in normal driving.

 

Opps, that was before... It's actually reading -70 to 60Kpa... how do you change it to psi?

 

You just have to change the units. It can be done on the AP and in ATR.

Just flip through the screens on the AP, there aren't that many of them. I think it's called settings.

 

bah, I'll play around with it I guess! I'm pretty sure I have it set on Standard