Hey,


I was trying to bench an evo x ecu that was locked.
I checked all the wiring and everything is connected properly.

Recovery mode in ecuflash has been selected.

When i try to write the file on the ecu, this is what i get:

[22:57:22.203] sending init sequence 1 (0001)
[22:57:23.218] got 0x05 response
[22:57:23.218] sending init sequence 2
[22:57:23.234] got 0x1A response instead of 0x1B
[22:57:23.234] sending init sequence 3
[22:57:25.250] error sending init sequence 3
[22:57:25.250] interface close


Any ideas?


Cheers

 

double check everything

make sure the wires aren't touching other pins

make sure you have the right options in ECUFlash selected..

make sure you are writing the right ROM

try doing a read...