Error While Benching the ECU
#1
Evolving Member
Thread Starter
Error While Benching the ECU
Hey,
I was trying to bench an evo x ecu that was locked.
I checked all the wiring and everything is connected properly.
Recovery mode in ecuflash has been selected.
When i try to write the file on the ecu, this is what i get:
[22:57:22.203] sending init sequence 1 (0001)
[22:57:23.218] got 0x05 response
[22:57:23.218] sending init sequence 2
[22:57:23.234] got 0x1A response instead of 0x1B
[22:57:23.234] sending init sequence 3
[22:57:25.250] error sending init sequence 3
[22:57:25.250] interface close
Any ideas?
Cheers
I was trying to bench an evo x ecu that was locked.
I checked all the wiring and everything is connected properly.
Recovery mode in ecuflash has been selected.
When i try to write the file on the ecu, this is what i get:
[22:57:22.203] sending init sequence 1 (0001)
[22:57:23.218] got 0x05 response
[22:57:23.218] sending init sequence 2
[22:57:23.234] got 0x1A response instead of 0x1B
[22:57:23.234] sending init sequence 3
[22:57:25.250] error sending init sequence 3
[22:57:25.250] interface close
Any ideas?
Cheers
Thread
Thread Starter
Forum
Replies
Last Post
wreckleford
Lancer Engine Management / Tuning Forums
7
May 20, 2012 11:35 AM