So do you see this all the time or just that log? From the plot itself it looks like maybe even a little clutch slip that maybe we've never been able to log before because of the log resolution?

Your plot looks like a mini version of what I see when I get logged clutch slippage with my SST:

 

I only have 1 log at the moment... my evo is being a garage queen atm

I guess it could be slip, but that would be odd, especially since this is not at peak tq...

 

I have seen some load errors where the decimal point gets put in the wrong place, but that 5003 looks like it should read 5013.
I like Ceddys answer though.

 

thats because of MUT only being a single byte protocol.

this is however many bytes we like... so there isn't any high/low byte mismatch going on