projekX

iTrader: (-1)

OK Guys, sorry it took so long but here ya go:

SUSPENSION: HKS Hipermax III Sport Coilovers

Wheels: Volk Racing TE37 19x10.5 +12
Rubber: ADVAN Neova 265/30/19

The height is set a little conservative for a few weeks or a month until i see how much the springs settle. Then i will do some adjusting and possibly a wheel alignment and we're good


This image has been resized. Click this bar to view the full image. The original image is sized 800x641 and weights 279KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x415 and weights 205KB.

This image has been resized. Click this bar to view the full image. The original image is sized 799x418 and weights 204KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 221KB.


And on da car

This image has been resized. Click this bar to view the full image. The original image is sized 999x664 and weights 611KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 412KB.

This image has been resized. Click this bar to view the full image. The original image is sized 1977x1022 and weights 1304KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 433KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 379KB.

This image has been resized. Click this bar to view the full image. The original image is sized 1156x1422 and weights 541KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 368KB.

This image has been resized. Click this bar to view the full image. The original image is sized 1424x2144 and weights 817KB. This image has been resized. Click this bar to view the full image. The original image is sized 1424x2144 and weights 779KB. This image has been resized. Click this bar to view the full image. The original image is sized 799x531 and weights 299KB.

smabe123

gah, i want to love the car, but i just cant. Those wheels are sticking out too far. Maybe if your fenders were flared, and the car was slammed on the wheels. Beautiful wheels though.

endz

iTrader: (1)

Damn, I don't know how I feel about them, they need a lot of work to make it look proper, but to you for even having them on.

Something tells me I would like them glossy rather than matte, but that's me.

So much lip on that thing dammnn, the concaveness gets overlooked? It's hard to tell from those pictures.

I really can't say I love them as much as the specs make them out to be. Would need it to be widebody or fender work. Need to get those wheels flush.

ApexSafety93

Excellent stuff

STItoEVOX

iTrader: (2)

better get some RA mudflaps for them bad boys.

aftershock141

iTrader: (9)

18x9.5 +15 SBC RPF-1.

I tried to do HDR but pretty much failed. Oh well. Better pics to come tomorrow.

AWM3

iTrader: (2)

You can go much lower. Wheels are amazing, but I'm still not feeling 19" wheels on EVO's. I like 18" that are wide with an aggressive offset.

MR Dan

iTrader: (8)

You need some front camber plates set at least 3 degree neg. camber to clear the fenders during compression

Ultimateone

iTrader: (10)

Yup wayyy too much poke

Spunkysandoval

iTrader: (7)

That will clear with -2.5 no problem. You wont even need to roll the fronts. Just trim a 3 inch strip of the liner fromthe bumper all the way to the side marker and then bend the tabs up with your hand strength. This will clear with a 1 finger gap. You also need to cut out the front tab area and just bend it under the bumper to pinch it and hold it in place.

The rear will need - 2 degrees of camber and a tab removal. Do the same thing in the rear for the tab. Bend it under and pinch the bumper to hold it in place

Hydrolikz

aftershock141 What's the deal with the taillights? And projkX how come your CF looks so faded?

endz

iTrader: (1)

i just noticed the half ralliart lights

interesting

projekX

iTrader: (-1)

HKS Hipermax III Sport COMES WITH CAMBER PLATES

Fractur3

iTrader: (12)

one of them broke in shipping, so im guessing to make it look not too odd, he matched the color on the other side...

empirepb210

iTrader: (1)

correct me if im wrong, but i believe thats the more expensive dry carbon