Kahtec Blinking Brake Lights
#1
Kahtec Blinking Brake Lights
I had the Kahtec Blinking Smart Stop Plus 3 Delay Version on my 2011 WW debadged Evo X today and they worked out pretty well. Having almost been rear ended a few times in traffic, it seemed liked a good idea.
Here is the vid demonstrating the version I purchased.
http://www.youtube.com/watch?v=cT9c-z1lWvI
Here is the vid demonstrating the version I purchased.
http://www.youtube.com/watch?v=cT9c-z1lWvI
#3
He is 13 and scared to death to get in the car (for now). He has only driven the automatics up and down the drive way, so new territory.
If you hit the brakes they flash and then stay solid (not flashing) until you let off (of course). If you reapply the brake within eight seconds of letting go they do not flash. So in the vid I had him count to 10 and then reapply to watch them blink again.
Not bad for 40 bucks. Other versions only flash the third brake light which was not that compelling.
If you hit the brakes they flash and then stay solid (not flashing) until you let off (of course). If you reapply the brake within eight seconds of letting go they do not flash. So in the vid I had him count to 10 and then reapply to watch them blink again.
Not bad for 40 bucks. Other versions only flash the third brake light which was not that compelling.
#4
Evolved Member
iTrader: (14)
Hahahaha. Which one is the brake..
Pretty cool. Seems like it would work well. I've never been rear ended but I did have a stupid lady put her car in reverse and back in to me at a red light. Haha. What all has to be done to install this? Just some relays or something?
Pretty cool. Seems like it would work well. I've never been rear ended but I did have a stupid lady put her car in reverse and back in to me at a red light. Haha. What all has to be done to install this? Just some relays or something?
#6
The package came with everything you need (including instructions and wiring schema) except one wire had to be extended (cut and crimp), but overall pretty simple connection job (took about an hour). All done in the trunk and completely hidden. The device connects in front of the brake lights except for the ground connection, so it can provide the blink.
Here is the link:
http://www.kahtec.com/products.htm
I did not do a lot of research of other products but it appeared to be a inexpensive yet not very invasive option.
#13
Sorry to bump an old thread, but OP, can you just write up a brief set of instructions (if you still remember them), I am not very familiar with electricals. I did understand the instructions they have provided, but while I am waiting on the module to arrive, I figured I would try and best understand this, so that I can get it done without any issues.
Thanks for you help!
Thanks for you help!
Thread
Thread Starter
Forum
Replies
Last Post
Revo15
Evo X How Tos / Installations
14
Dec 17, 2019 06:35 PM
FRSport.com
EvoX 'For Sale' External Engine / Power
9
Apr 14, 2019 11:25 PM
BPAuto
EvoX 'For Sale' Exterior Styling
1033
Oct 20, 2016 02:57 PM
2011, 3rd, brake, evo, flashing, gsr, installation, installing, kahtec, lancer, light, lights, mitsubishi, mode, tail