Sink Strainer Dual Exhaust Mod
Ditched the strainers.
Found some sweet 4" tips.
Made the cardboard as a template due to the fact that I ****ed up the holes.
Think I'm gonna get a piece if aluminum and polish it.
What do you guys think??
Found some sweet 4" tips.
Made the cardboard as a template due to the fact that I ****ed up the holes.
Think I'm gonna get a piece if aluminum and polish it.
What do you guys think??
I'm back!
She currently on the lift at my friendly neighborhood Meineke.
Guys here at this particular one are very cool.
Two of them can't wait to hear how she'll sound.
To be continued...
She currently on the lift at my friendly neighborhood Meineke.
Guys here at this particular one are very cool.
Two of them can't wait to hear how she'll sound.
To be continued...
I'm liking it!
I would think angled down exhaust tips would look better than straight out like the sample pic you posted.
Something like the top one or middle exhaust tip. The burnt tips would set it off IMHO.
I would think angled down exhaust tips would look better than straight out like the sample pic you posted.
Something like the top one or middle exhaust tip. The burnt tips would set it off IMHO.
Last edited by SilverShadow03; Jun 17, 2014 at 11:37 AM.
Almost finished except the tips.
I left the pipe sticking out 2" for now temporary till I decide on what tips.
The last tips I found don't work.
Here's a video I just took to hear the sound.
The engine is warm, I revved a few to 3k then the last rev was almost 6k.
It sounds diffrent in the video and realife, but you get the idea.
Also some pics
Enjoy!
For the haters and the non vision :P
I left the pipe sticking out 2" for now temporary till I decide on what tips.
The last tips I found don't work.
Here's a video I just took to hear the sound.
The engine is warm, I revved a few to 3k then the last rev was almost 6k.
It sounds diffrent in the video and realife, but you get the idea.
Also some pics
Enjoy!
For the haters and the non vision :P
Last edited by MR. EVO MR; Jun 17, 2014 at 04:29 PM.
The pictured exhausts are for motorcycle or ATVs. I was simply using the pic as a reference...I've seen almost identical automotive mufflers with the same angled down tips I posted.
Here is a link to a site with similar products....
http://getmycaranexhaust.com/
Also, IMHO, I would use larger diameter tips...those look too small... I would go fart can size or just below it (3" - 4") seeing how you have limited space...also, I'm sure you'll clean up the exit holes to make them more symmetrical to one another right? :-)
Looking good!
Here is a link to a site with similar products....
http://getmycaranexhaust.com/
Also, IMHO, I would use larger diameter tips...those look too small... I would go fart can size or just below it (3" - 4") seeing how you have limited space...also, I'm sure you'll clean up the exit holes to make them more symmetrical to one another right? :-)
Looking good!
Last edited by SilverShadow03; Jun 18, 2014 at 03:18 PM.
^^
Reason I ****ed up the holes- Originally I wanted the exhaust a little higher, but then decided to have them lower.
Work and family is keeping me from finishing, I hope to finish soon before my turbo upgrade.
Reason I ****ed up the holes- Originally I wanted the exhaust a little higher, but then decided to have them lower.
Work and family is keeping me from finishing, I hope to finish soon before my turbo upgrade.
