I'm installing my UEGO wideband and am wanting to know how to route the wire back into the interior to hook up to the gauge? I'm mounting the wideband sensor into my test pipe. I'm sure its been posted before and would normally search but I'm doing this right now and am running out of daylight. Any help appreciated

 

I run my lc1 through the hole where the engine harness goes through the firewall

 

where is that? I'm looking but not seeing where it goes, I'll take a general location so I can find it.

 

i got the perfect place

go under your car look by the shifter area by the ending of your down pipe

there should be a rubber gourmet

pop it out it should lead by the passenger side

 

My wideband is feed through the rubber drain plug on the passenger side.

 

under the carpet located kind of under the radio correct?

 

Yep thats pretty close to the spot maybe more to the passenger side.

 

yea thats where i got mine perfect place

 

to the right you cant miss it

 

sit in your passanger seat. Where your left foot sits. Take out the panel and pull the carpet up. Its on the firewall and its like a 3" gromet for the main engine harness

 

Alright, on to taking apart the interior to get it

 

haha better explained had a hard time describing it

 

ohh ok let me go check...

 

Got it, Awesome spot!!

 

btw
you might have to pry open the hole a bit wider to fit the o2 sensor. i had to.