how to adjust forge IX wastegate?
Thread Starter
Joined: Mar 2007
Posts: 546
Likes: 45
From: Boca Raton FL
how to adjust forge IX wastegate?
Well...
i got the rod tention adjusted to were the car is boosting 23-24 PSI ,
but the taper is worse now than before!?
is the allen hean srew on the body off the wastegate an adjustment srew?
Thanks!!
i got the rod tention adjusted to were the car is boosting 23-24 PSI ,
but the taper is worse now than before!?
is the allen hean srew on the body off the wastegate an adjustment srew?
Thanks!!
Why not go right to the source? Forge Motorsports USA, is located in Orlando, Florida. Contact them! They carry different rate springs.
Last edited by sparky; Oct 12, 2007 at 04:17 AM.
How are you controlling boost my friend? Do you have a boost controller, either manual or electric? If so which one? Did you the get boost level all the way up to 23# strictly by shortening the actuator rod? What gear are you testing boost in? Hey will you list all the power mods on your car?
Last edited by sparky; Oct 12, 2007 at 04:27 AM.
Thread
Thread Starter
Forum
Replies
Last Post
urnamehere
Evo General
5
Oct 13, 2010 12:01 PM
