o2 housing - quick question
#5
Evolved Member
iTrader: (51)
Join Date: Sep 2005
Location: cincinnati
Posts: 1,981
Likes: 0
Received 0 Likes
on
0 Posts
this is the gasket for between the o2 housing and turbo hotside http://www.lancershop.com/customer/p...&cat=15&page=1
and you may also need a new donut gasket http://www.lancershop.com/customer/p...&cat=15&page=1
and you may also need a new donut gasket http://www.lancershop.com/customer/p...&cat=15&page=1
#7
Evolving Member
Thread Starter
iTrader: (2)
Join Date: Feb 2007
Location: Chicago
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
Can I grab the gaskets off of a mitsu dealership?
I'm planning on doing the install tomorrow so I need them asap
If not mitsu, then where would be the best place if I needed them immediately?
I'm near a couple evo shops so would they possibly have any instock?
I'm planning on doing the install tomorrow so I need them asap
If not mitsu, then where would be the best place if I needed them immediately?
I'm near a couple evo shops so would they possibly have any instock?
Trending Topics
#9
Evolved Member
iTrader: (1)
Join Date: Mar 2005
Location: Mesoamerica/ SF Bay Area
Posts: 7,905
Likes: 0
Received 5 Likes
on
5 Posts
Only use genuine Mitsubishi factory gaskets in the turbine housing-O2 housing area as well as at the turbine housing-exhaust manifold interface. Been there, done that!
Last edited by sparky; Sep 20, 2008 at 09:51 PM.
Thread
Thread Starter
Forum
Replies
Last Post
IX_MR
Evo Engine / Turbo / Drivetrain
2
Jan 16, 2013 07:44 PM