I've installed my power fc and AVCR recently.Got 2 problems :

1). The readings for the Injector Duty cycle shwon in the AVCR and power FC comander is not the same. In my AVCR shows as for example 62% but in my commander is 1.2%.

2). My 2nd problem is the Water Temp readings in commander shows like 90+ degrees but standard water temp gauge not even needle didn't even go up more than half.

Anyone got similar problems like mine? Can someone help me out on how to rectify this problem.

Thanks..

well it should be obvious which is correct
the PFC is taking them from its own calcuation and injector driver

the avcr would be getting them from one signle injector pulse wire and counting pulses i would expect. is the PFC one correct? (it should be)

half way on my r33 skyline is about 80deg water temp

tommi_mak, have you found out anymore information regarding this issue? i'll be running a power fc with avc-r as well soon so i'd like be prepared for any issues i may encounter before hand.

thanks!

tru tru

I know this thread is sooo long time ago... I've just recently plugged in my AVC-R with my Power DJetro on my evo 8. Has anyone figured out why? Perhaps I've tapped in the wrong wire?