I'm wondering if anyone out there has any experience with setting up speed density and tuning using Tunerpro RT. I have a GM 3 bar MAP sensor and IAT sensor, but I'm no sure of the tweaks that have to be made in tuning the ECU to make the new hardware work in place of the stock MAF sensor. I've heard a lot about VE tables, but I'm not sure if I'd have to make these up from scratch or if I can modify existing tables. Any help is greatly appreciated!

 

I think its best from scratch

 

Don't think you will get much help with that on here.

If I was going to go speed density with an I-III, I would use ECMLink. Speed density is basically plug and play.