I wanna Speed Density!!!! :-D

P.s. already have the bung in the intercooler piping :-)

 

Cool I hope to have a preliminary patch ready this weekend though I guess we'll see if my family can interrupt that process

 

:-D

 

Is the AIT sensor required? I was reading that some dont even use it

 

I bought it, it was only like 25 bucks why not lol

 

Delayed a bit my weekend was taken up mostly with my niece and activities

Not a bad way to go but does delay efforts. I'll try to get some code time on monday night I'll keep you guys posted. Another win is I finally got myself dehooked from one of my RPG games so I'll be more free to do stuff lol!

 

Hahaha no prob spiker! ill be awaitin!

 

ROM is mostly done still a few things to do like disable the baro ODBII codes and the MAF sensor codes. I'll try to set this rom up the best I can but since this will be the first SOHC car thats gone speed density I wager the VE settings are going to be much different than normal so I'm unsure what will happen.

 

As long as my car dont blow up its cool. What do i need to do instalation wise? I have the IAT sonsor, i have a bung on the intercooler piping, how do i wire it up? Also got the MAP sensor ready to go as well

 

The map sensor should just plug into the car. The IAT needs to be wired to the car's fuel temp sensor as its the easiest to do without messing up the car's ability to switch back. I don't know what pin the fuel temp sensor is so we can look that up with a pinout digram.

 

If I do switch I think I'd rather get it tuned by Reese Tuning here in San Diego

 

RS, Im not sure if I already asked you this, but can we disable the EGR through the ECU Periphery?

 

There are two places one I think disables the test and ignition timing but the other actually stops the actuator. I can't remember if i defined the actuator one for you guys or not but i'm guessing not.

 

This one?

 

Thats one and this table is the other.
<table name="EGR Disable (Set to 0)" address="101d" type="1D" level="1" scaling="uint8"/>