Reprogramming an ECU DIY Lancer CS 2004
#1
Newbie
Thread Starter
Join Date: Mar 2017
Location: QLD
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Reprogramming an ECU DIY Lancer CS 2004
so recently did an engine swap over and my mechanics (back yard) but a coil plug and other plug back the front. Only 2 cylinders will start. I got out an auto elleci after blowing 4 coils because the 2 cylinders weren't firing and he said the switched plugs friend the ecu. There is no burn marks on the ecu that I can see of bubbles.
I got a new ecu then was told I will need to reprogram that ecu... apparently it's a very expensive job.
Theres a possibilty that there is a crushed wire in the loom however the auto elleci said it's fine :/
i want to know if i can easily reprogram the new ECU and how?
ANY HELP WOULD BE AMAZING
I got a new ecu then was told I will need to reprogram that ecu... apparently it's a very expensive job.
Theres a possibilty that there is a crushed wire in the loom however the auto elleci said it's fine :/
i want to know if i can easily reprogram the new ECU and how?
ANY HELP WOULD BE AMAZING
Last edited by Bell Wallbank; Mar 20, 2017 at 09:50 PM. Reason: Car model
Thread
Thread Starter
Forum
Replies
Last Post
Blizzard25
Evo X Engine Management / Tuning Forums
0
Sep 7, 2014 04:27 PM
Danieln
ECU Flash
25
Apr 9, 2009 04:16 PM