It makes sense to you? Can you explain how? I can take a look at the as@ end of a car and tell you what car it is but I couldn't make a bumper for the damn thing from sight.

Looking at the back of the TB and then trying to make a better gasket doesn't make sense to me. Taking the stock gasket and making one based off of that does though.

Could you please explain how the picture of the TB's back helps in this situation.

 

+1

boe is right. a picture is not enough to make a gasket; or any part for that matter.

 

lol I ment to say doesn't make sense to me.... my bad.... I'm actually getting irratated that its taking so long for this to get resolved.... I just wish someone from RPW would answer my email so I know what is going on

 

They tend to take a day or so most of the time. Different time zone and totally different day. They are probably ordering the gasket and gearing up for a redesign so that they can get you the right piece.

Sucks that you're going thru this.

 

No cores yet. We will keep an eye out for them

ROAD/RACE

 

damn!!!! I'm sure all the flooding we had last week set it back a couple days..... that sucks ...... lol I can't wait to get my header now

 

Nothing yet.

ROAD/RACE

 

I talked to someone on thephone today he said you have recieved the cores..... I just want to make sure that this is right

 

I was in meetings today. I can find out tomorrow.

ROAD/RACE

 

awesome ....... I can't wait to get my header

 

my header is getting shipped out tomorrow........ how long does shipping usually take?

 

Figure 6 business days

ROAD/RACE

 

should I replace the gaskets for the header I have approx 37,000 miles on my car

 

i would replace it just to be on the safe side. just take a peek and you'll know if it needs to be replaced. judging by your location, i would assume the roads are pretty salty in the winter so i would recommend a new gasket.

 

header should be here any day now.... I can't wait.... does the header come with the CEL eliminator?