head 4g94
#1
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: canada
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
head 4g94
ok my new project for my head 4g94 is near finish but i need valve. does it have valves in stainless which are compatible with our head? at present I have valvesprings aftermarket of camaro lc1, a custom cam racing for 8000rpm,fidanza cam gear, head ported.I need valve
I saw that with valve of VW vr6 they would be possible to modify them for our 4g94 butis very custom...
I saw that with valve of VW vr6 they would be possible to modify them for our 4g94 butis very custom...
#2
Evolved Member
iTrader: (23)
Join Date: Aug 2002
Location: Lynnwood, WA
Posts: 2,204
Likes: 0
Received 0 Likes
on
0 Posts
Why not just buy a new set of the stock valves? Getting too custom with valves can be bad, as you will likely grind through the case hardened layer and expose the heat intolerant, rust prone, softer steel underneath.... unless you have an industrial style heat treat shop at your disposal. Then it could work.
How do you plan on making your lower end handle revving to 8K RPM? And you're aware that the fuel cut is at about 6250 RPM, right? Even revving to 7K (if you haxored teh ECU) would be a no-no on a stock crank and pistons.
How do you plan on making your lower end handle revving to 8K RPM? And you're aware that the fuel cut is at about 6250 RPM, right? Even revving to 7K (if you haxored teh ECU) would be a no-no on a stock crank and pistons.
#3
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: canada
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
I don't have a stock block.. and i have aem ems like computer.I have a good setup turbo and many custom part. The 4g94 can ride 8000rpm but the cam oem is to bad for this.. I made a custom cam for 8000rpm with the good duration...
Thread
Thread Starter
Forum
Replies
Last Post