What did you do to your Lancer today
what do the clips looks like? I have some mitsu clips i got when replacing the inner rear fender panel that was missing on her car. They are black, have a small head that you push down and it snaps in place. Only way that one would work is if they are placed in a hole on the bottom of the strip and then you would just push the whole thing down in the hole.
Evolved Member
Joined: Nov 2013
Posts: 624
Likes: 0
From: nj
what do the clips looks like? I have some mitsu clips I got when replacing the inner rear fender panel that was missing on her car. they are black, have a small head that you push down and it snaps in place. only way that one would work is if they are placed in a hole on the bottom of the strip and then you would just push the whole thing down in the hole.
No the weather lining strips ise differnet clips
Thread Starter
Evolving Member
Joined: Feb 2014
Posts: 238
Likes: 1
From: Florida
Evolved Member
Joined: Nov 2013
Posts: 624
Likes: 0
From: nj
Newbie
Joined: May 2010
Posts: 51
Likes: 0
From: yuma, AZ
Newbie
Joined: May 2010
Posts: 51
Likes: 0
From: yuma, AZ
I did some work to my OZ today. I removed the bottom piping of my AEM CIA and made it to SRA. Everytime it rained, the air filter would suck in water from the water puddles and hydrolock the engine. Today was cloudy and i didnt want it to happen again lol i rinsed all the parts with the water hose and i think the sensor is still a little wet cuz my idle RPMs are at above 1k, it should be lower. Hopefully on my drive to work it will reset itself. Also noticed the bottom piping had a huge holr in it lol
