I swapped out my winshield washer nozzles for some 04-06 Galant nozzles to get that mist-like spray effect. I don't have any pics of what it looks like right now but I did take a pic while the swap was in progress.

 

Projectors with 5000k bulbs. They don't look 5k

 

Where did you get the hids?

 

eBay.

 

I was thinking about getting the depo headlights with H7 and getting some HIDS from ddm tuning

 

man. lot of catching up to do on here. seems that I am not being notified when new posts are up. meantime, daughter's car been gone to college so nothing new there. did do a little somethin to the snake though...

 

Well, last night I sent the car off to a transmission ship. We think the tranny finally failed, it had 250,000 miles on it. We knew it was gonna fail soon. The shop is going to look over the tranny and see if we could just rebuild it, or if I'm gonna need a whole new one. :/ sad that she's gone for awhile tho. but I know she'll be back and ready for hell that I can give her. Lol. Shouldn't have really anything to b broken on the cat aft this. Nothing major that is. Fingers crossed!

 

Changed my alternator & battery, unfortunately I didn't snap any pics.

 

need to find a reasonably priced source for the two roof black strips and probably the clips that hold it on. either that, take them off and paint them myself. anybody done that? how hard is it to take off the strips. thanx.

 

Ive taken mine off before but on one side the clips were sol old they broke the the lining doesnt sit right . Ill prob take it to the dealer eventually .. but when your taking it off be gentle

 

does it take a special tool or what did you use. do they just snap straight down? thanx again.

 

They do make a special tool to take them off. But if you're replacing them, you won't need one to install them. The tool is just to keep from damaging them. I replaced both of mine after I got it painted. Cost around 130 or so from the dealer and all the clips came with them

 

can't afford that right now...may just try to get them off and painted. do you have any idea what the tool looks like? thanks for the info.

 

Also, you can buy the clips from the dealer for a few bucks a piece. I was able to get mine of without damaging the strips and only breaking the plastic pieces. I just decided to replace them because the plastic was cracked from a hail storm. So I got Both so they would match.

 

what do the clips looks like? I have some mitsu clips I got when replacing the inner rear fender panel that was missing on her car. they are black, have a small head that you push down and it snaps in place. only way that one would work is if they are placed in a hole on the bottom of the strip and then you would just push the whole thing down in the hole.