here is my V2 intake installed, i took a pic of where i bolted the support beam to and i havent had any troubles at all. the only thing i didnt like about the intake was i had to find a part to secure the intake to the engine, i just cut up the old rubber intake thing and that works fine but it sounds really good.


THATS THE BOLT FOR THE SUPPORT BEAM.





PICTURE OF THE ENGINE BAY AT A ANGLE.





PICTURE OF THE INTAKE.





PICTURE OF ENGINE BAY FRONT ON.



as you can also see i did a bit of painting to, i plan to do a bit more but i gotta find the perfect colours first.

 

Do you have any problems with your heatshield touching/rubbing up against the wireharness? I had my hood open the other day and was looking at it and it seems a little too close for comfort. At least I didn't notice any signs of melting, just the adhesive on the tape was warming and sliding slightly.

 

my heatshield doesnt touch anything, its completely free from wires or anything

 

Thanks, I'll have to look at mine again, maybe I'll pull it off and rebend that support thing to try to push it further away.

 

you shouldnt have to bend anything my one install with out bending anything. lol maybe your installing it wrong i dont no but you shouldnt have to bend anything

 

so idle it for 15min? I wonder how much gas it will burn in that time

 

Am I gonna have any problems installing this intake on a pen. emmissions lancer?

 

Does anyone know what size the bolt is (threadwise) for the arm that connects the intake to the frame?

 

Is it C.A.R.B. certified? If I install this in 2009 Lancer GTS and go to a smog check in the near future will it pass? Thanks.

 

Mine is touching the wires too, RRM said it's normal?

 

nice work here good visual ... even a caveman can do it right!

 

I want to slap a AEM or AMSoil filter than the oil gaze. What is the Diameter of inlet?

3 inches?

 

does anyone happen to know the thread size and length of the stock hardware for the stock airbox? I'm going back to stock and need to get hardware for it