Hi everyone,

I am from Russia. I've had a Lancer X 1.8 MT. I bought it in mid of 2008 year. Unfortunately for Russia Mitsubishi Motors is produced cars without SWITCH Trunk lid opener we can open lid with key only. During looking at some topics of this forum I've seen that all the USA cars have SWITCH,TRUNK LID OPENER.

I have found neccessary parts of that in MMC USA:

5927A013 LATCH,TRUNK LID
5927A004 SWITCH,TRUNK LID OPENER
MB590337 RETAINER,TRUNK LID LOCK CYLINDER

I can buy it separately in Russia and install on my car, but in service manual I didn't find any scheme for connection it to car. Could you please provide me with information about that and may be someone have a electrical scheme for connection it to car? It would be greate to have photos with cable color. Please help me

 

why dont you just go to ur local mistubishi dealer and tell them what u want?

 

Unfortunately, my local dealer is not good. I try to tell them about what I want, but they tell me that they can't help me.

 

Just wondering, Is this that chrome ring around the switch?

 

The wires should get to the KOS ECU which is behind the driver knee airbag. It should go on the biggest connector from what I could see, 2x20 pins. Pin 1 of the switch goes to Pin 28 of the connector, and pin 2 goes to ground. This is assuming u have the keyless entry system.

 

Thanks a lot for answer. Is it possible to get photo of this connector?

 

No. It is this device:

 

i dont have plans for opening up my trunk, else i would post one.