How to Swap your ECU...
#1
How to Swap your ECU...
1. Open your glove box on the left hand side there is a romovable tab...
2. Remove it...
3. grab the right hand side of the glove box and push left to get the tab over
4.
5. open the glove all the way towards the floor and it will pop off
6. grab a hold of the wire harness cover and pull it towards you
7. unplug the ecu
8. remove the three black 12mm bolts
9. the ecu should fall to the floor
10. to remove the ecu from the metal bracket use a flat head screw driver and pry on the outer edge.
11. then reverse to get everything back in...
2. Remove it...
3. grab the right hand side of the glove box and push left to get the tab over
4.
5. open the glove all the way towards the floor and it will pop off
6. grab a hold of the wire harness cover and pull it towards you
7. unplug the ecu
8. remove the three black 12mm bolts
9. the ecu should fall to the floor
10. to remove the ecu from the metal bracket use a flat head screw driver and pry on the outer edge.
11. then reverse to get everything back in...
#3
#4
Evolved Member
iTrader: (5)
Join Date: Apr 2010
Location: Jupiter
Posts: 663
Likes: 0
Received 0 Likes
on
0 Posts
I think the written instructions alone are enough guys, this isn't difficult... If you are not sure how to do this then you probably shouldn't be doing it, you could potentially F yo car up people.
#5
For example, I can't find the tabs he's talking about in the glovebox. I really shouldn't have to explain more than that. The only reason I'm even looking for help is because I can't find the information in the service manual.
Thread
Thread Starter
Forum
Replies
Last Post
darkmitsu
Lancer Engine Management / Tuning Forums
141
Dec 31, 2022 05:41 AM
concept11253
Evo How Tos / Installations
11
Jul 17, 2014 05:48 PM
mci2727
Lancer How Tos / Installations
4
Jan 30, 2013 10:06 AM