04 Lancer ES 2.0 Throttle Cable Adjustment
#1
Newbie
Thread Starter
04 Lancer ES 2.0 Throttle Cable Adjustment
So I frequently (every 3 months or so) have to remove my intake duct and clean out my throttle body. It's no biggy; it's rather easy to do. But I noticed this time around my throttle cable is a bit loose, with what i feel is a tad bit of extra slack. They'd a miniscule amount of delay from the pedal too the cable. So I tried looking up done videos to no avail on how to adjust it. Any help would be highly appreciated.
#2
There are 2 screws there 10mm i believe
unscrew them and slightly pull back on the cable till it feels snug. Make sure your not pulling to hard and opening the throttle body a little. Just enough to where it feels tight.
unscrew them and slightly pull back on the cable till it feels snug. Make sure your not pulling to hard and opening the throttle body a little. Just enough to where it feels tight.
#4
Thread
Thread Starter
Forum
Replies
Last Post
llDemonll
Evo Engine / Turbo / Drivetrain
4
Aug 17, 2015 08:54 AM
dzraduzit
Evo Engine / Turbo / Drivetrain
8
Jul 26, 2007 06:15 PM