Basic 2004-2006 Ralliart Audio Info
#16
Thread Starter
iTrader: (14)
I didn't have an adapter to make the 6.75" speakers fit (they were too big to work with the 6.5" adapters that came with the previous speakers.) Basically, the 6.75" speakers were big enough to sit on top of the hole, but not big enough to reach the screw holes, which is why I used zip ties and foam (to prevent rattles.) At some point I'll go back and make a proper adapter out of 1/4" plywood, but at the moment, I don't really care that much.
#17
Anyone know where I can find myself one of these? I've looked everywhere!
http://images.importtuner.com/featur..._dashboard.jpg
http://images.importtuner.com/featur..._dashboard.jpg
#21
Newbie
Join Date: Aug 2008
Location: fullerton california
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Here you go....
12v constant- red/black
Ground- antenna, just plug your antenna in
Ignition- blue/yellow
illumination- green/white
power antenna- yellow
left front speaker...+red/white -red/blue
Right front speaker...+red -green
Left rear speaker ... +white/blue -yellow/red
Right rear speaker... +lt.green -yellow/green
12v constant- red/black
Ground- antenna, just plug your antenna in
Ignition- blue/yellow
illumination- green/white
power antenna- yellow
left front speaker...+red/white -red/blue
Right front speaker...+red -green
Left rear speaker ... +white/blue -yellow/red
Right rear speaker... +lt.green -yellow/green
#24
Evolved Member
Join Date: May 2005
Location: naples,fl
Posts: 644
Likes: 0
Received 0 Likes
on
0 Posts
What is the diagram for hijacking the stock amp and powering an aftermarket amp to run a single sub i happen to have some stuff laying around and am rusty on audio system but have never jacked into another amp to power another exe. pm me or answer here thanks
#27
Newbie
Join Date: Aug 2008
Location: fullerton california
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
you only use a line out converter if you are trying to put an aftermarket amp in. a line out converter will just convert the signal and let you use RCA's for an aftermarket amp. you can just use the pos. and neg. wire that plug into your factory sub. you can take those and hook them up to the aftermarket sub, but the power and ohm load will be wrong and it won't sound that great...
#28
Anyone know where I can find myself one of these? I've looked everywhere!
http://images.importtuner.com/featur..._dashboard.jpg
http://images.importtuner.com/featur..._dashboard.jpg
is it just the bezel or a lcd radio with the bezel and hvac relocation bezel?
#29
Newbie
Join Date: Aug 2008
Location: fullerton california
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
that is just a dash kit that comes with a hvac relocation kit. its an expensive kit though and hard to find. usually runs about $300. the radio can range anythere from $600 to $1400
#30
wow, ok im going to have to look around and rig some thing to move hvac! i want to add a gps, but do not want it on the wind shield. i would like it where the hvac is at. if something come to mind i will add pics and a how to! so far i have added a dome light with skulls hanging down above the rear view mirror! tuff but fun!