I said, I DID NOT HAVE SLIPS. The car just got its trans in a couple weeks ago. I do have a dyno. Someone remembers. I will take a picture of it.

ROAD/RACE

 

to make those calipers fit what kind of wheel would they need to put on there? like whats recommended size

 

awesomeness.. tranny mods? "fully built" is a broad statement

 

car looks great guys, im in for slips and dyno #'s. also im curious as to the cost of all the mods done to the car, a rough estimate is fine. Thanks guys and keep up the great work

 

I think it has to be no smaller than an 18 or 19 inch wheel. I'm trying to get my hands on the bbk but don't plan on going any bigger than 17, so I'd be able to run 330 at the largest.

 

post it up.

 

Busy but when I get a minute to scan it in I will.

ROAD/RACE

 

waiting on that slips!!!!

 

Heck sick lookin ride +1

 

Can't wait to see slips! Slick looking car though.

 

Sick lancer, I wAnna see that dyno sheet

 

When the owner takes it to the track, he will get the slips. He is the owner of the car so he does what he does. But he did a great job on the car.

ROAD/RACE

 

damn that's a hella nice ride

 

you said you were going to post up dyno numbers like 2 weeks ago. at least give us those while you wait.

 

Seriously been too busy building a car for American Suzuki. IF you do not beleive it, you will see it on TEST DRIVE with Tommy Kendall. We will finish it in a couple weeks and filming will be April 5,7,8. Not sure when it airs. Check Speed Channel for that epsiode with Suzuki. That is gonna be us.

ROAD/RACE