Link to Marc's youtube?

Looking good Dallas! I need to get off my *** and get more work done!

 

Heh, the wife says Im a workaholic... I just like to think I'm productive.

 

definately going to get some of those arms one day haha. dallas gona sponsor me i heard

Ill snap a couple pics of the splitter and mountings tonight.

I also have a video from qualifying from the other weekend. its just raw gopro footage of the whole session but i can upload it if u guys wana watch it? prob about 8 or 9 laps in there. Get to see the mixture of cars we go up against. and see just how quick those daytona prototypes are. despite having 500kw they make u look like ur in a honda civic when they go past

 

Yes, please, on splitter pics!

 

**** the axle clips. the passenger's side is slightly out of round and fighting me the whole way trying to get back in. the driver's side was way tighter and it clicked back in. i'll probably have to grab a new clip from the dealer and get back at it tomorrow

 

which axle clips? the ones the CV's click into in the trans shaft?

Sorry no splitter pics til thursday dads taken it back to do some more work to it after i ran it over the other week hahah.

 

I think he's talking about the circlip on the inner shaft that splines into the front diff. I would check the splines on the shaft as well. I had to replace a shaft the last time I had my engine out, the splines were a bit goobered up from going in and out previously and didn't want to go back in nicely.

 

yep, this ****ing thing

https://stmtuned.com/products/axle-c...=1455569567753

sorry that was a rage quit post last night after failing to get the axles back into the diff. not a happy situation. the driver's side, which still has a tight clip, clicked in, but the passenger's side with it's enlarged clip did not.

ordered new clips, will try again tomorrow night... then i can test out the new diff that i got for the 2019 season

 

 

i'll take a closer look but the splines i think are fine. where are u putting the hammer?

 

definately shouldnt need a hammer they should just click in by hand with a good solid push. Ive had a damaged circlip before and i tried hammering it and it made it worse. damaged the hub nut threads too eeeek.

Just get a new clip put on the shaft. its simple n cheap. or take the clip off urself n give it a birthday in a vice. u shud be able to push them in by hand but not pull them out by hand

 

yup. i think it's just slightly out of round and i was able to pull it off. makes me a little nervous about the splines, i'll take a look tonight to make sure i haven't damaged them forcing the ****er in. the clip on the driver's side, as you indicated, i cant even get a fingernail to pull it out if i tried. the passenger's side i can get out with relative ease.

i've also had those silver plates fall off the green part of the axle, i need to clean those up and get them on too

 

Link to full quali session as promised. unfortunately the gopro was full for the first race blew the crown wheel in the transfer case 3 laps in anyway

Got pretty busy on the first flying lap with people coming out the pits n stuff!!

 

 

^^^Nice job out there Brad. There were some heavy hitters out there

Joe