Thanks everyone so much for the help. I finally got them out. Lots of penetrating oil with a night to soak, then two impact guns on either side and some serious hammer blows and finally got them out. After that everything went smooth. MR suspension installed! Now I just need an alignment. Too bad it cost me a day and a new impact gun. Would have been cheaper to have it done! Haha.

 

Was going to say acetone and ATF for a penetration oil.

http://grassrootsmotorsports.com/for...t/13650/page1/

And its cheap to create 50/50 mix in a spray bottle.

 

Hmm i missed this thread. Sounds exactly like what i went through. Mine took 2 days for my top bolt to break loose. torching and hammering. nothin like it. who needs a gym!