<SOLD>EVO IX 2.3L Stroker Engine built by Alfred Beltran @ Tuning Technologies in Colton, CA. Alfred is well known in the SoCal EVO community for his high quality engine building and dyno tuning experience.
Engine was designed and built as a reliable 500+ HP street motor:

All parts are New

EVO IX Virgin Block w/Oil Squirters and Main Stud Girdle
Block has had the following procedures:
Jet Washed
Magnetic Particle Inspected
Bored and Align Honed w/Torque Plate
Block Deck Surfaced
Eliminated Balance Shafts
ARP Head Studs
ARP Main Studs

EVO IX Virgin Cylinder Head
Head has had the following procedures:
Thermal Clean and Baking Soda Blasted
Inspected for Flash and Debured
Valve Stem Heights Set and Checked
Valve Spring Pressures Measured

OEM Mitsubishi 2.4L Crankshaft
Checked for Straightness
Magnetic Particle Inspected
ACL Coated Race Bearings

Pistons
JE #2618 Forged Coated Custom Stroker 9.0 CR
JE ProSeal Rings

Rods
Eagle w/ ACL Coated Race Bearings

Precision Engine Assembly
File Fit Ring Gaps
Set All Bearing Clearances
Eliminated Balance Shafts

Cams
Cosworth EVO IX M2 (272 Duration)

NEW OEM EVO IX:
Front Case
Oil Pump
Water Pump
Timing Belt
Master Gasket Set

Pics:

Red stuff is Cam Lube


The engine has 0 miles, is completely assembled and sealed in plastic. I am selling because I have decided to buy a new car instead. Cost $8000, sell $5500 OBO. Can be shipped. <SOLD>

Call or PM Mark Ph: 571-334-2169

 

Bump

 

Bump

 

Bump

 

still no pics is the problem

 

yes you need pics!

is that for the long block?

 

Bump. What kind of car are you getting next?

 

Not sure yet, hopefully something fast. Well maybe not as fast as an EVO....

 

Bump for a legit shop that does good work

 

Bump

 

Pics man

 

TKEVO what's up?

You can't see the pics

 

how much just for the bottomend 2.3L dont need the cylinder head..
I'm in socal so no shipping would be required

 

PM sent

 

Bump