STM -6 valve cover fittings
Thread Starter
Former Sponsor
iTrader: (79)
Joined: Jun 2007
Posts: 2,340
Likes: 5
From: Rochester, NY
STM -6 valve cover fittings
Finally back in stock! Sorry about the wait guys. Anyone who had orders pending have been shipped today!
For those who do not know what these are. I have added a few details.
Always looking for ways to make the engine bay cleaner, lighter and easier to work with, STM designed these little, aluminum fittings to allow you to simply install -6AN lines and fittings for a catchcan or breather right onto your valve cover.
As the piece itself is a very tight fit, we would definitely recommend a bit of glue or epoxy to help hold it in place in the valve cover upon install.
Here's a comparison on the rear fitting vs the stock mess we previously had to run:
Installed
These install withing minutes. Simply pull the old fittings out with a pair of pliers and slip the new ones in. I would suggest tossing the new ones in the freezer so they shrink up a little as it is a tight fit!
They can be found here.
http://www.streettunedmotorsports.co...r_fittings.htm
As always, Thank you for your support!
-STM
For those who do not know what these are. I have added a few details.
Always looking for ways to make the engine bay cleaner, lighter and easier to work with, STM designed these little, aluminum fittings to allow you to simply install -6AN lines and fittings for a catchcan or breather right onto your valve cover.
As the piece itself is a very tight fit, we would definitely recommend a bit of glue or epoxy to help hold it in place in the valve cover upon install.
Here's a comparison on the rear fitting vs the stock mess we previously had to run:
Installed
These install withing minutes. Simply pull the old fittings out with a pair of pliers and slip the new ones in. I would suggest tossing the new ones in the freezer so they shrink up a little as it is a tight fit!
They can be found here.
http://www.streettunedmotorsports.co...r_fittings.htm
As always, Thank you for your support!
-STM
Thread Starter
Former Sponsor
iTrader: (79)
Joined: Jun 2007
Posts: 2,340
Likes: 5
From: Rochester, NY
Thanks for posting up the pic and I am glad you like them!
Carlos, We will be at the shop all day tomorrow. Give us a call and we can get them right out.
Thanks
-Em
Carlos, We will be at the shop all day tomorrow. Give us a call and we can get them right out.
Thanks
-Em
Trending Topics
Thread Starter
Former Sponsor
iTrader: (79)
Joined: Jun 2007
Posts: 2,340
Likes: 5
From: Rochester, NY
Thanks again guys!
Don't forget, these can be picked up at any of our dealers as well.
AWD Motorsports
Buschur racing
lancer shop
Force fed
Ivey tune
Spec ops
And so on!
Merry Christmas Everyone!
-Em
Don't forget, these can be picked up at any of our dealers as well.
AWD Motorsports
Buschur racing
lancer shop
Force fed
Ivey tune
Spec ops
And so on!
Merry Christmas Everyone!
-Em