SE Vishnu Dyno Day! May 15th GA
Originally posted by Noize
Even though it reads "lower", I feel that Dyno Dynamics is by far the best system to tune from in that it has more features and is far easier to operate and strap down.
Even though it reads "lower", I feel that Dyno Dynamics is by far the best system to tune from in that it has more features and is far easier to operate and strap down.
Originally posted by Noize
Snoop, if you'd like to see a correlation of what your car would put down on a dynojet, you can multiply the number you receive by 1.2 and have a close approximation. There is a excel file on Shiv's site entitled "How big is your horsepower" or something of that sort that allows you to plug in numbers and see how different dynos would typically read out.
Even though it reads "lower", I feel that Dyno Dynamics is by far the best system to tune from in that it has more features and is far easier to operate and strap down.
Seth
Snoop, if you'd like to see a correlation of what your car would put down on a dynojet, you can multiply the number you receive by 1.2 and have a close approximation. There is a excel file on Shiv's site entitled "How big is your horsepower" or something of that sort that allows you to plug in numbers and see how different dynos would typically read out.
Even though it reads "lower", I feel that Dyno Dynamics is by far the best system to tune from in that it has more features and is far easier to operate and strap down.
Seth
Evolved Member
iTrader: (20)
Joined: Mar 2003
Posts: 4,941
Likes: 0
From: Danville/Blackhawk, California
Originally posted by Dyno4mance
Actually Seth our Dyno is proving to read almost right on 17% lower than a Dynojet...I am not sure but I am sure Vishnus dyno is really close to ours....so I think 20% is a bit over IMHO
Actually Seth our Dyno is proving to read almost right on 17% lower than a Dynojet...I am not sure but I am sure Vishnus dyno is really close to ours....so I think 20% is a bit over IMHO
It is also interesting to note that Dynojets can read very differently from each other. I've seen as much as 20whp difference between difference AWD Dynojets. At Pruven, Stage 1s were making 315-320whp. At Altered Atmos, the same car/set-ups were doing less than 300whp. Not sure if this is based upon differences in software or actual hardware variances. So I guess the correction factor betwen DD dynos and Dynojets may vary between 12% and 17%, depending on what Dynojet we are comparing it to. But really, who wants to compare their numbers to a Dynojet?
Those who haven't used a DD dyno before will be in for a pleasant surprise when it comes to tuning and set-up. It's really in a class by itself. And after seeing pics of Dyno4formance's shop, I think we are going to have on helluva weekend.
See y'all in May!
Shiv
Last edited by shiv@vishnu; Mar 30, 2004 at 10:51 AM.
As was brought up before by myself and hanstercat...will shiv be updating our Xedes with the new firmware? Or do we have to send them in to Vishnu beforehand (makes little sense and costs us shipping)?
Dyno4mance, you can change my tune to XedeFlash tune on 93/100 octane. Stage 1 right now, should have cams before the dyno day though...
Dyno4mance, you can change my tune to XedeFlash tune on 93/100 octane. Stage 1 right now, should have cams before the dyno day though...
Saturday 15th May 2004
1 Noize = Race gas stage 1 custom tune
2 Paul Hignut = Xede tune/ xedeflash (a must)
3 John Ward (WRX Ecutek custom tune)
4 Ryanmcd= Stage 1+ Custom tune
5 Limey= at least an xedeflash+ custom tune
6 Dude= Xedeflash custom tune on stage 1+ 93/100
7 markluuv=stage 1+custom tune
8 iS300= Xflash
9 Toddevo8=Xede and Xedeflash
10 TreyS + on the fence
11 Snoop= Dyno day
12 MYEVOVIII = Dyno day
13 silverEVO8 = Dyno day
14 rallyred= Stage 1 custom tune, xedeflash, (maybe stage 1+?)
15 Event-Horizon= Xede, not sure about custom tune?
Tis done ....
1 Noize = Race gas stage 1 custom tune
2 Paul Hignut = Xede tune/ xedeflash (a must)
3 John Ward (WRX Ecutek custom tune)
4 Ryanmcd= Stage 1+ Custom tune
5 Limey= at least an xedeflash+ custom tune
6 Dude= Xedeflash custom tune on stage 1+ 93/100
7 markluuv=stage 1+custom tune
8 iS300= Xflash
9 Toddevo8=Xede and Xedeflash
10 TreyS + on the fence
11 Snoop= Dyno day
12 MYEVOVIII = Dyno day
13 silverEVO8 = Dyno day
14 rallyred= Stage 1 custom tune, xedeflash, (maybe stage 1+?)
15 Event-Horizon= Xede, not sure about custom tune?
Tis done ....
In Timeout
Joined: Mar 2004
Posts: 45
Likes: 0
Sounds good, now what do we need to do to get the xede flashes and the upgraded firmware?
Originally posted by Dyno4mance
Saturday 15th May 2004
1 Noize = Race gas stage 1 custom tune
2 Paul Hignut = Xede tune/ xedeflash (a must)
3 John Ward (WRX Ecutek custom tune)
4 Ryanmcd= Stage 1+ Custom tune
5 Limey= at least an xedeflash+ custom tune
6 Dude= Xedeflash custom tune on stage 1+ 93/100
7 markluuv=stage 1+custom tune
8 iS300= Xflash
9 Toddevo8=Xede and Xedeflash
10 TreyS + on the fence
11 Snoop= Dyno day
12 MYEVOVIII = Dyno day
13 silverEVO8 = Dyno day
14 rallyred= Stage 1 custom tune, xedeflash, (maybe stage 1+?)
15 Event-Horizon= Xede, not sure about custom tune?
Tis done ....
Saturday 15th May 2004
1 Noize = Race gas stage 1 custom tune
2 Paul Hignut = Xede tune/ xedeflash (a must)
3 John Ward (WRX Ecutek custom tune)
4 Ryanmcd= Stage 1+ Custom tune
5 Limey= at least an xedeflash+ custom tune
6 Dude= Xedeflash custom tune on stage 1+ 93/100
7 markluuv=stage 1+custom tune
8 iS300= Xflash
9 Toddevo8=Xede and Xedeflash
10 TreyS + on the fence
11 Snoop= Dyno day
12 MYEVOVIII = Dyno day
13 silverEVO8 = Dyno day
14 rallyred= Stage 1 custom tune, xedeflash, (maybe stage 1+?)
15 Event-Horizon= Xede, not sure about custom tune?
Tis done ....
Originally posted by hanstercat
Sounds good, now what do we need to do to get the xede flashes and the upgraded firmware?
Sounds good, now what do we need to do to get the xede flashes and the upgraded firmware?
Cams are on order. The race begins, hopefully they'll make it in before the dyno day. No answers on the phone from Vishnu.
On another note, inferencing from other posts, it seems during the NJ and Portland Dyno days that all Xede's were updated to the newest firmware version that solves the cold idle and misfire codes by bypassing the MAF at low loads. Good news. Shiv is at this very moment trying to perfect the launch control feature of the new firmware (which was not installed in the previous dyno days). Even better news.
With any luck this means we might-could (southern talk) get launch control too. I think updating Xedes with the new firmware is pretty much a foregone conclusion, but I will still ask anyway...
As for those wondering if they will be performing XFlash on site I would lean in the same direction (afterall, they are tuning them) but I'll be nice and ask about that too. IF anyone answers the phone.
Noize, you've been to a couple of these, you should be able to answer some of these questions. Oh, and I guess Boost Solutions is planning on also getting their AWD DD Dyno up and running by then. Imagine that, two of em' only about an hour apart.
On another note, inferencing from other posts, it seems during the NJ and Portland Dyno days that all Xede's were updated to the newest firmware version that solves the cold idle and misfire codes by bypassing the MAF at low loads. Good news. Shiv is at this very moment trying to perfect the launch control feature of the new firmware (which was not installed in the previous dyno days). Even better news.
With any luck this means we might-could (southern talk) get launch control too. I think updating Xedes with the new firmware is pretty much a foregone conclusion, but I will still ask anyway...
As for those wondering if they will be performing XFlash on site I would lean in the same direction (afterall, they are tuning them) but I'll be nice and ask about that too. IF anyone answers the phone.
Noize, you've been to a couple of these, you should be able to answer some of these questions. Oh, and I guess Boost Solutions is planning on also getting their AWD DD Dyno up and running by then. Imagine that, two of em' only about an hour apart.
I'm compiling a lot of data to post, but am waiting for the official word from Shiv on a couple of things before I do anything.
He just got back in the shop after like three straight weeks of dyno days, so he certainly deserves a breather.
As soon as I have the complete information, I will post it for ya, bro!
He just got back in the shop after like three straight weeks of dyno days, so he certainly deserves a breather.
As soon as I have the complete information, I will post it for ya, bro!
Missed part of your post, Dude. Shiv will definitely be able to perform Xflash/XEDEflash upgrades on site. He will bring the necessary equipment to do this.
Stay tuned to find out the answer to the firmware update question as well as scheduling, pricing, and hotel information. There are still a few details that require approval from Shiv and Andrew.
Thanks so much for everyone's continued patience. This event is going to be truly awesome!
Stay tuned to find out the answer to the firmware update question as well as scheduling, pricing, and hotel information. There are still a few details that require approval from Shiv and Andrew.
Thanks so much for everyone's continued patience. This event is going to be truly awesome!
Last edited by Noize; Mar 30, 2004 at 01:54 PM.
Hey shiv, do I need to do anything in advance so that you will bring a XEDE unit for me? I was planning on paying for it the day of the event. Let me know if you need any info from me.
Thanks!
Thanks!
In Timeout
Joined: Mar 2004
Posts: 45
Likes: 0
George has been saying he has been getting a dyno for months.
Originally posted by dude
Cams are on order. The race begins, hopefully they'll make it in before the dyno day. No answers on the phone from Vishnu.
On another note, inferencing from other posts, it seems during the NJ and Portland Dyno days that all Xede's were updated to the newest firmware version that solves the cold idle and misfire codes by bypassing the MAF at low loads. Good news. Shiv is at this very moment trying to perfect the launch control feature of the new firmware (which was not installed in the previous dyno days). Even better news.
With any luck this means we might-could (southern talk) get launch control too. I think updating Xedes with the new firmware is pretty much a foregone conclusion, but I will still ask anyway...
As for those wondering if they will be performing XFlash on site I would lean in the same direction (afterall, they are tuning them) but I'll be nice and ask about that too. IF anyone answers the phone.
Noize, you've been to a couple of these, you should be able to answer some of these questions. Oh, and I guess Boost Solutions is planning on also getting their AWD DD Dyno up and running by then. Imagine that, two of em' only about an hour apart.
Cams are on order. The race begins, hopefully they'll make it in before the dyno day. No answers on the phone from Vishnu.
On another note, inferencing from other posts, it seems during the NJ and Portland Dyno days that all Xede's were updated to the newest firmware version that solves the cold idle and misfire codes by bypassing the MAF at low loads. Good news. Shiv is at this very moment trying to perfect the launch control feature of the new firmware (which was not installed in the previous dyno days). Even better news.
With any luck this means we might-could (southern talk) get launch control too. I think updating Xedes with the new firmware is pretty much a foregone conclusion, but I will still ask anyway...
As for those wondering if they will be performing XFlash on site I would lean in the same direction (afterall, they are tuning them) but I'll be nice and ask about that too. IF anyone answers the phone.
Noize, you've been to a couple of these, you should be able to answer some of these questions. Oh, and I guess Boost Solutions is planning on also getting their AWD DD Dyno up and running by then. Imagine that, two of em' only about an hour apart.
In Timeout
Joined: Mar 2004
Posts: 45
Likes: 0
Hey man, you need to call him and order it, Todd got his today. I am excited I will not be the only one with a xede one anymore 
Originally posted by Event-Horizon
Hey shiv, do I need to do anything in advance so that you will bring a XEDE unit for me? I was planning on paying for it the day of the event. Let me know if you need any info from me.
Thanks!
Hey shiv, do I need to do anything in advance so that you will bring a XEDE unit for me? I was planning on paying for it the day of the event. Let me know if you need any info from me.
Thanks!