First Ecuflash read triggered "Service Engine Soon" Light
#1
Evolving Member
Thread Starter
iTrader: (12)
Join Date: Apr 2006
Location: cali
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
First Ecuflash read triggered "Service Engine Soon" Light
Okay so I tried doing the first ecuflash read on a 2014 Mitsubishi Ralliart. Cable was brand new tactrix 2.0, tablet was brand new as well running windows 10. Ecuflash and evoscan was loaded on the tablet with no problems.
So I connected the tablet to the tactrix cable which was connected to the obd port. Tried to do a read but Ecuflash says definition files were missing. After I got that message I turned ignition to off position then disconnected cable. I tried to start car to make sure it would still start. Car started fine, but now I have a service engine soon light that won't go off. I used evoscan and tried to read the code. Evoscan detected no codes. So I hit the clear dtc codes button anyways and says codes cleared. Then I started the car again and service engine soon is still on.
Any ideas? Btw, never had this problem using a 1.3u cable on an evo ix.
So I connected the tablet to the tactrix cable which was connected to the obd port. Tried to do a read but Ecuflash says definition files were missing. After I got that message I turned ignition to off position then disconnected cable. I tried to start car to make sure it would still start. Car started fine, but now I have a service engine soon light that won't go off. I used evoscan and tried to read the code. Evoscan detected no codes. So I hit the clear dtc codes button anyways and says codes cleared. Then I started the car again and service engine soon is still on.
Any ideas? Btw, never had this problem using a 1.3u cable on an evo ix.
Thread
Thread Starter
Forum
Replies
Last Post
worksevo89
Evo Engine / Turbo / Drivetrain
16
Nov 13, 2008 03:00 PM
TINMAN
General Engine Management / Tuning Forum
2
Jan 15, 2007 10:55 AM
'ringmeister
Evo Engine / Turbo / Drivetrain
17
Jan 8, 2005 07:54 PM