kj1976

I have a 2001 Mitsubishi Mirage 1.8 and I am replacing the front-struts. Taking the front right strut off took no more than 30 minutes.

*Tools: Socket wrench with a 17mm for the lower bolts and a 15mm for the top bolts under the hood.
*Spring Compressor Tool used to remove the old strut and add the new one.
*Jack Stands - Lifted both sides up for removal

Once everything was put together I attached the strut back in the correct position and I noticed that the strut holes did not match up where they should be.

My question too you great mechanics, as a newbie what should I do to get the strut to match up so I can add the bolt and screws back?

Checking other responses stated that I should put a screwdriver in the hole to match it up. The problem there is that the way it is angled, I can't put a screwdriver in the hole. Any thoughts on the issue?

Photos attached..

DannyG90

Has anyone figured this out yet?? I'm having the same problem right now

.M.

Use some wd40... or whatever you prefer. Try a hammer. Maybe a breaker bar. Have a friend help. Push up/down on the hub. It'll line up. Just keep at it.