Removing the Clutch Master Cylinder
Dec 27, 2006, 09:35 AM
#1
Evolving Member
Thread Starter
Join Date: Feb 2006
Location: Phoenix,Az
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Removing the Clutch Master Cylinder
Okay guys, so i tackled this job last night. To my surprise it was not hard at all. Took me about 30 mins (including taking pics) So here goes ..hope it helps some one out.
cheers
Myron
1-drain the fluid in the resavoir
2-discconect the hose
3-loosen the banjo bolt
4-carefully remove it with both copper screws
5-locate the 2 bolts that hold the Master cylinder form inside the clutch. Loosen both of them
6-disconnect attachment from clutch pedal
7 remove master cylinder
8-U GOOD TO GO(now i had to flip mine around in order to get it out of that small place.
GOOD LUCK
cheers
Myron
1-drain the fluid in the resavoir
2-discconect the hose
3-loosen the banjo bolt
4-carefully remove it with both copper screws
5-locate the 2 bolts that hold the Master cylinder form inside the clutch. Loosen both of them
6-disconnect attachment from clutch pedal
7 remove master cylinder
8-U GOOD TO GO(now i had to flip mine around in order to get it out of that small place.
GOOD LUCK
Last edited by MyRoN; Dec 27, 2006 at 10:28 AM.
Thread
Thread Starter
Forum
Replies
Last Post
MyRoN
04-06 Lancer Ralliart How To Requests / Questions / Tips
6
Apr 24, 2012 06:45 AM
MyRoN
04-06 Lancer Ralliart How To Requests / Questions / Tips
17
May 21, 2008 05:20 AM
MyRoN
04-06 Lancer Ralliart How To Requests / Questions / Tips
4
Feb 11, 2008 09:33 PM
