when you guys installed a hid kit on your car did you also have to change the fuses to the headlights? and if you did, wich ones were they or what numbers were they in the fuse box?

 

no, you don't need to touch the fuses at all

 

yeah just a plug and play kind of thing..."out with the old in with new" deal....

 

Sorry This Guy if I'm about to thread jack but I figured since you got your answer already it woudln't be a problem. Anyway...

I was wondering on HID kits if it is necessary to get the ballasts or if I could just use the brighter bulbs? and do 9007 HID kits have the high/low beams or is it just one brightness setting?

 

You must use a ballast and there are hi/low (bi-xenon) HID kits available.

 

its all good!, well i just installed my hid kit but my high beams wont turn on, i notice it after removing those lil light bulbs on the top of the headlights, also do you guys know how to adjust the head lights?. my passenger side is pointing lower and i need to adjust it. thanks!

 

Check your bulb, it is probably not seated in their properly. I did the same thing when I installed my xenons

 

Isn't there some screw or bolt that you have to turn to adjust the height of the beam?

 

are you putting them in stock headlights? not sure how to adjust those. as far as the hi beams not working, make sure you have be-xenon HIDs

 

yeah i got them in stock headlights, i think they shipped me the wrong kit.

 

there's a screw on the lower part of the headlight to adjust the height reflection on your lights... it has a 10mm screw... the passengers side is difficult to reach... but you CAN adjust it!!!!

if you bought Bi-Xenon you should have 4 ballasts... if you bought hi/low HID kit, it uses a motorized bulb... that moves the bulb to the front to get a higher beam... if your bulb doesn't move then it's just single/low beam!

motorized: (not bi xenon)


PS: PM'd you This Guy!!! yes it was me lol....

 

they do move but i think theres a problem in the wiring harness, when i have time i will go back in and check, everything is connected fine tho

 

oh! yeah well maybe the ballast isn't working well... good luck!