What about off throttle boost?

 

i just got my car back after a shop put a base map in it for me and while on the two step the car reaches 15psi is that ok i know the factory 2step had me at 10psi

 

ok im newer to the car game i have a stock ems and want a 2 step i have read it helps but isnt perfect can i plug my computer into my stock ems? in order to do the settings yall say if so how? thanks in advance

 

yes i was wondering did you just flash your current ecu?

 

does this setups works on the aem ems 1313 for evo 8?

 

Yes. All aem systems have a stationary rev limit option with the ability to antilag

 

Thanks for the info

 

I am on nittos 555r drag radial tires on a 6262 setup and I was bogging out @ 6400rpm. I am on a aem series 2 on my Evo 8. So I raised it pretty high(7400) just to see if it helps, then I was going to gradually turn it down. Now, I know that may sound pretty high but it seemed to work for me. Mind you, I only did one launch on the street with the tire pressure @ 34 psi. What I wanna know is, am I crazy to be doing this time and time again on stock axles, driveshaft and stock rear end? Remember this is on an unprep'd street. I figure I want a little tire spin. Rather than hook and bog, which is also bad for your drivetrain. Right????

 

with that much tire pressure and an un prepped street, youll be fine. it should just spin like crazy. especially launching that high of an RPM. if anything does happen to break, more than likely its from dumping the clutch etc.

 

I have a built trans and transfercase with a os geiken twin disc. When I did that test launch, it spun just enough, then hooked and shot me all the way to redline. It felt good. I am just concerned that it might be to much RPM to keep launching that way?

 

if it works, it works. try lowering it a little and see what happens. 2 step is really just driver preferance and it not bogging out..

 

Thanks