C U Friday Dude !

 

ah, so this is what your car looks like! They didn't offer a rear trunk lip spoiler?

 

MR gets no spoiler and it's $2800 for a factory one (*******!) so a $1200 c/f ducktail from do_luck sounds delicious.

 

Hey BC guys! I need some help/favour.
Im just starting the official process of bringing in a IX, and Ill be going over to richmond to lp auto so they can appraise my 350z and talk about prices for the evo.
I was wondering if there is anyone around victoria, or in richmond area that would be cool to meet up so I could get a look at an evo ix up close, Ive never seen one and don't want to 'test pilot' your car. Just want to have an up-close look at one before I start dropping cash even tho I know Im going to get one.
Ill be in richmond thurs. May 20.
PM me if you're interested in helping me out! Thanks.

 

hmmm interesting. i went to lp auto too. they took in my 350z roadster and imported me an evo. i have an viii. few 604/778 guys have the ix. GL.

 

Thanks man, anything to say about lp auto, talked to a guy there for a bit today telling him what I was looking for, etc.
Did they give you a reasonable price for your Z?

 

ill send you pm

 

I'm in richmond just give me a call ... pm you

 

anyone have any inside information if ER is having another tune session soon? i get back on June 10th and leave again for Hawaii from June 29th, til July 29th, so i kinda like to get my clutch put in when it back, break it in and get it tuned before i leave lol.

 

they just had a dyno day event in seattle early may. i doubt that they will hold another event like that, not for a few months anyways. i will let you guys know if i find/hear anything. i would send JohnBradley a pm to see if you can make any arrangements for a tune.

 

i just sent them an email, and Aaron got back to me

he said that they're not going to be down in Auburn area prob until August to September.

but he did say he'll tune my car for a very good price, so i think when i get back on the 9th of June im going to get the ACT HDSS clutch in it right away (unless UPS fails me) break it in, and head down with a few gas containers in the trunk.....which im sure i am going to get a LOT of attention from the guys at the border.....

cant wait to feel the difference in power, ive seen works P2 flash put down only 280awhp @20psi on a Dynojet (no surprise since its just boost refinement). i hope to break 330 @24psiwith the new tune. i dont know if i want to take my high flow cat out yet, i got an Ultimate racing Test pipe just itching to go in.

 

what other mods to u have vince?

i have tbe with high flow cat, intake, ets ic pipings, walbro 255, 94 octane and ER tune. im sitting at 325 awhp and 315tq (dynojet numbers)

 

Hey guys, it looks like I won't be coming over to Richmond this thurs. afterall, so thanks for getting back to me and offering to meet up. Hopefully another time soon!

 

im running Works TBE with works HFC, Works large throttle body, Amsoil cone intake, Hallman Pro MBC, ETS LICP.

i dont think i'll need a walbro for just 24psi tune, but i'll definately get it down the road.

 

you should get the fuel pump in before your tune. this way, you wouldnt have to worry about the stock one bottle necking. get it done right away. its only 100 bucks anyway. a lot of ppl would recommend the fuel pump in the first wave of mods before a tune. but check first because you might already have it. hahahaha