i need to adjust the clutch rod out...i have been trying to slip it a few times with NO luck ...i think the biggest problem is not the fact that the clutch is too grippy or can't be slipped but i think that its cause of the fact that it fully ingages at the bottom /floor

 

good run slick

 

Yep, I would agree with that, TRE even said the clutch should engage about 3'' from the floor.

 

going to adjust it today and road test it!

 

Nice Dave, Have tym extend your rpms a few hundred rpms or so that going thru the traps at the top of 4th. And turn up the boost to 30-32 psi. for pete sakes....J/k Nice run but you definatley have a 10 in there for sure.

 

i loaded the software into our laptop so i can do it...i am going to also up the air pressure in the tires to help aid in some wheel slip, adjust clutch and some other minor stuff....i will make some passes at higher redline at the same 27 psi....then go from there.

 

Well shiz, just program a 2 step at 5500-5800 rpms to make the launch easy to repeat. If you get wheel hop it is to high, if it bogs not enough etc... good luck man...that is one nice set up you have.

 

https://www.evolutionm.net/forums/sh...d.php?t=153046