Oh sorry I was only seeing "lean spool" in the title and not 2byte load. Yes, the new Evoscans are setup to log 2byte load as well

 

So that emans no formulas or anyhting have to be flashed into the ROM. Just check off 2 byte laod in EVOscan and log?

 

FINALLY a "how-to" that makes sense. using plain english. thank you!

 

question 1: i did all the stuff on the first page. is it wrong? 'cause now i'm reading page after page of how it's not right. or am i reading wrong? was the first page edited and up to date?
question 2: after adding "lean spool disable", i didn't see it. so i did it again. after closing the program and re-opening it.. i now have two. i can i delete one? i checked throughout the roms and can't find it anywhere.

 

**edit. i tried the "<table name="Lean Spool Start RPM" category="Misc" address="1680" type="1D" level="1" scaling="RPMStatLimit"/>

<table name="Lean Spool Stop RPM" category="Misc" address="1684" type="1D" level="1" scaling="RPMStatLimit"/>"

so now i have that AND the first ones that i can't get rid of! screen shot:



now.. i know i can go into the ROM and delete the "start rpm" and "stop rpm" boxes... but i'd rather keep those and get rid of the "lean spool enable" and the two "lean spool disable" ones..

i erased ecuflash... reinstalled... the enable/disable/disable options are still there. how can i get rid of them, pleeeease?

 

you need to find .xml for your rom. ex. (88590015) and open up your .xml w/ notepad, and delete any defs. you dont want, such as the disable/enable def.
open up ecuflash, and they should be gone...

 

I think my ecuflash version might be wrong, which Periphery Bit is used on an IX 88590015 to disable lean spool? FBA bit 0?

 

yeah FBA i thought...

 

I read on here FBA bit 7 though, I had FBA bit 0