I installed everything perfectly, and it runs perfectly. Only problem, the directions instruted me to deleted my high/low 2,3 timing tables. I went ahead and deleted them.
Now the issue.... The car still uses the 2,3 tables. I make changes in my high 1 table and the do not effect the cars timing in boost.

Any ideas?

Do I need to reload ecuflash and get the definitions for the High 2,3 tables again?

 

I just kept my tables since I tune cars that don't have the patch as well. Someone can probably toss you the XML you need so you don't have to add everything else back in. I would but i don't have my laptop here at work.

 

yeah i would be greatful just to get the xml back, so I dont have to reload everything.

 

what do u mean its still using table 2 and 3?

 

When I download the rom off the car, The High/low 2,3 ignitions maps are still there and being used. Although i dont have access to them anymore in ecuflash.

Did i miss something where the car would only read off the high/low ignition 1 map?

for example i set timing at 250ecuload at 8 degrees, its still only going 5 degrees because that is what was set in high/low 2 table.

 

yes they remain there but shouldn't be used.

what romid?

are you actually using the V5 rom? ie do the V5 settings show up correctly in ecuflash?

are you on normal or altmaps?

post up that bit of the log?

 

im on normal not alternative.

and when i make adjustments in high timing 1, nothing changes.

Ill get a log up

 

maybe your XML is wrong as well, can you post your high ignition segment?