yeah, i would really appreciate it if you could.

for some reason, i only have this range on my map sensor, i suspected something was wrong with it or with my calibration at first, but these settings are spot on, although lacking a lot of resolution.

i am giving it a +5v reference and a clean ground, i suspected for a moment it might need +12v reference, but for some reason, i don't want to try and burn the sensor.

if nothing else works, i'll end up ordering an omni 4-bar map....

 

well i would find the spec sheet and confirm the numbers are correct.

if the sensor is buggered (OR you using the wrong PIN on the ECU) then now is the time to fix it