Tactrix cable missing second connector
Thread Starter
Evolving Member
iTrader: (13)
Joined: Aug 2009
Posts: 154
Likes: 1
From: Houston/Lubbock, TX
Tactrix cable missing second connector
So I got my tactrix cable today from a guy (who im assuming) had a suby. this cable has the obd connector with 3 pins on the top (wider end) and 4 pins on the bottom (smaller end).
what it does NOT have, is the extra white connector that comes out of the obd plastic clip.
stupid question, but what does that wire connect to inside of the plastic obd tactrix connector? I didnt even get the plastic connector for mitsu's, i got two small ones for subies.
im wondering if i can add it in myself, or if im just SOL... again.. any help would be greatly appreciated.
what it does NOT have, is the extra white connector that comes out of the obd plastic clip.
stupid question, but what does that wire connect to inside of the plastic obd tactrix connector? I didnt even get the plastic connector for mitsu's, i got two small ones for subies.
im wondering if i can add it in myself, or if im just SOL... again.. any help would be greatly appreciated.
Plug it into a PC, and see what the device identifies itself as; see this chart (under "USB Description") to identify which cable you have, and what capabilities it has.
Thread
Thread Starter
Forum
Replies
Last Post
Mitsu.kid.02
Lancer Engine Management / Tuning Forums
217
May 25, 2016 10:47 AM
