Hi,

I usually wouldn't make my own thread for a question like this but I am in a pinch and need a quick fix if possible.

I just had a chance to get my car back up and running and cannot get the registration (currently expired) renewed until I pass emissions. I was using the V7 for a while, but switched back to my stock map so obviously I went to put the patch on the car to make it force pass OBD inspection. I also just re-installed EcuFlash and EvoScan in my laptop that had to be re-imaged.

I patched my 96940011 map and the SES light and codes in the ECU are still there. I have removed the codes twice but they just come right back on after a few on/off cycles. I am showing all 1's in my monitors for available and pass/fail.

I will reciprocate to the community by posting a full review for the BBK-B which I plan on tuning tomorrow morning.

Any help would be very much appreciated. I am tired of driving my other car.

Thanks

Justin

 

BBK-B dyno results TOMORROW if I can get this resolved.

Any takers?

 

Don't you have ot have some sort of tephra mods to enable the OBD patch?

 

I was under the impression that the patch mentioned was a stand alone. Haven't read the whole thread in a while. Just pulled the code out yesterday from the thread.

 

Did u try disabling them in the fca section. I'm on my phone now and can't remember which bits it is