Speed Density 2.0 (3D VE Tables, Baro)
#334
Evolved Member
iTrader: (7)
Join Date: May 2010
Location: Maine
Posts: 836
Likes: 0
Received 0 Likes
on
0 Posts
Ive been dialing in a 2D SD rom lately. MUCH harder to dial in, by the way... Maybe I'll give the new combo of fixes a try soon and report back. Are any others seeing the issue any more with And's combo of fixes?
#335
#336
Evolving Member
iTrader: (3)
I seem to get it very, very rarely, nothing like before. One thing I did notice my idle is way better and no throttle hang and my timing is not jumping around so much at idle.
Using Jitter 2,5&6 enabled. Anyone tried a different config.
Using Jitter 2,5&6 enabled. Anyone tried a different config.
Last edited by golruss; May 3, 2011 at 05:44 PM.
#341
Evolving Member
The only slight issue now is hot starting (after car has been run for a while then I stop and the start after a few minutes) from the heat soak in the temp sensor as the cars rpm drops and stalls but only for about 20-30 seconds and then all back to normal again
here's my rom, just to let you know the car is a 2.3 stroker, with RC1000's, MR turbo 3in exhaust, kelford 264 cams, no aircon, 3port, ruinning 2bar @3500 here a dyno plot also on this rom
Last edited by And; May 26, 2011 at 05:21 AM.
#342
Evolving Member
iTrader: (3)
I have no cold start problems now (after fiddling with various settings) and the car runs great
The only slight issue now is hot starting (after car has been run for a while then I stop and the start after a few minutes) from the heat soak in the temp sensor as the cars rpm drops and stalls but only for about 20-30 seconds and then all back to normal again
here's my rom, just to let you know the car is a 2.3 stroker, with RC1000's, MR turbo 3in exhaust, kelford 264 cams, no aircon, 3port, ruinning 2bar @3500 here a dyno plot also on this rom
The only slight issue now is hot starting (after car has been run for a while then I stop and the start after a few minutes) from the heat soak in the temp sensor as the cars rpm drops and stalls but only for about 20-30 seconds and then all back to normal again
here's my rom, just to let you know the car is a 2.3 stroker, with RC1000's, MR turbo 3in exhaust, kelford 264 cams, no aircon, 3port, ruinning 2bar @3500 here a dyno plot also on this rom
#345
Evolving Member
hehehe thats cause the one the car has 0009 but the rom I had on the memory card with me (which was the same before the patches) didn't have those patches applied and because I uploaded it in work I quickly changed them, I've now corrected it
Last edited by And; May 6, 2011 at 12:08 AM.